browser. Please upgrade your browser to improve your experience.

Amperes or Amps are a standard measurement of electrical current for how much electricity is moving through a wire at a set time. The amp draw is calculated by the electrical requirements of the devic [..]

Apparent Power is the product of root-mean-square (rms) voltage multiplied by rms current and the measurement by which power companies bill.

16-character Username & Password required for network administrators & user accounts. Multiple user accounts can be established with access rights only to designated outlets.

Crest factor is the ratio between the instantaneous peak current required by the load and the RMS current. High crest factor can lead to overheating of power supply components.

DCiE is the reciprocal calculation of PUE. 1/PUE = (IT Equipment Power x 100%)/Total Facility Power

International Electrotechnical Commission has a set of standard receptacles and outlets. Popularized because IEC plugs can output either 125 volts or 250 volts according to the cord that is plugged in [..]

The sentry family of products supports Lightweight Directory Access Protocol (LDAP) Version 3 including LDAPS (LDAP over TSL/SSL). This support enable authentication with LDAP servers; user accounts d [..]

National Electrical Manufacturers Association set of standard plugs and receptacles. NEMA nomenclature addresses the part configuration by locking ability (if applicable), 5 for 125V, 6 for 250 Volt, [..]

Time rate of doing work, usually expressed in horsepower or watts.