47 Industrial Way Buellton, CA 93427 P: (805) 688-4018 F: (805) 688-2075 E: info@allstarheatinginc.com

A ventilator captures heating or cooling energy from stale indoor air and transfers it to fresh incoming air.

A way to increase your home comfort and energy efficiency by controlling when and where heating and cooling occurs in a home. Programmable thermostats are used to control operating times of the equipment. Dampers are used to direct air flow to certain parts or “zones” of the home.

A type of furnace that draws cool air from the bottom and blows the warmed air out the top into the duct work. This type of furnace is usually installed in a basement or an out-of-the-way closet.

UL is an objective, non-profit organization that tests and rates electrical products for public safety.

Two Stage Compressors are capable of two levels of operation, a low stage and a high stage. Properly sized equipment will operate 80% of the time in low stage, enhancing efficiency and comfort with lower humidity levels and quieter operation. It’s like getting two air conditioners or heat pumps in one system.

A unit of measure for cooling capacity. One ton = 12,000 BTUs per hour.

A thermostatic expansion valve (TXV) is precision device used to meter the flow of liquid refrigerant entering the evaporator at a rate that matches the amount of refrigerant being boiled off in the evaporator.

Unit that monitors and controls your HVAC system products.

Refers to an air conditioner or heat pump that has components in two locations. Usually, one part of the system is located inside (evaporator coil) and the other is located outside your home (condenser coil).